-
paulwilkins authored
The initial allocation of bits in the two pass code to each frame should be within the min max limits on the command line. However, when forming an ARF group the cost of the ARF is shared by frames in that group such that the residual bits for a frame could drop below the min value. This change prevents the minimum being re-applied after the cost of the ARF has been deducted as this may otherwise cause low rate sections to overshoot their target. Test runs comparing to a baseline run with min and max section pct 0-2000% vs one closer to the YT use case (50-150%) suggest that this fix not only results in better rate control but also gives a better rd outcome. For example the HD set vs 0-2000% baseline (opsnr, ssim). Old code (50-150): +0.751, +1.099 New code(50-150): +0.241, -0.009 Change-Id: I715da7b130bf53ba8aa609532aa9e18b84f5e2ef
416b7051