Remove the unnecessary _s_ from their names, and add a new
vp9_recon_sb() that calls the y and uv variants.

Change-Id: I7ffaa5ff5605a8472cac2a53de8cf889353039a6

This experiment has failed to give much benefit but
does add complexity so deprecated.

Change-Id: Ic7b929ba706390b9907ef0b4f965bd401ca799a4

void __attribute__((noinline)) hi(void) { }
Causes build failure in VS2008

Change-Id: Ie2f2a09d90bd5502c492e4d9f4983532a0edbc01

Change-Id: I183ec5819d4d80966c92db36db75b8c3be0d381d

Use in-place buffers (dst of MACROBLOCKD) for  macroblock prediction.
This makes the macroblock buffer handling consistent with those of
superblock. Remove predictor buffer MACROBLOCKD.

Change-Id: Id1bcd898961097b1e6230c10f0130753a59fc6df

Adds RD integration for 32x16, 16x32, 64x32 and 32x64 rectangular blocks.
Derf almost +0.6%, HD a little over +1.0%, STDHD +1.3%.

Change-Id: Id651fdb6a655fdbb5c47009757e63317acfb88a5

Enable recursive partition information coding from SB64X64 down to
MB16X16. The bit-stream syntax is now supporting rectangular block
sizes. It starts from SB64X64 and recursively describes the partition
type of the current block. If the partition type is PARTITION_NONE,
the block is coded as a single unit; if it is PARTITION_HORZ or
PARTITION_VERT, the block is segmented into two independently coded
rectangular units, with no further partition needed; otherwise, the
block is segmented into 4 square blocks. i.e., PARTITION_SPLIT case,
each can be potentially further partitioned.

Forward adaptive probability modeling is used for the partition
information coding, conditioned on the current block size.

Change-Id: I499365fb547839d555498e3bcc0387d8a3587d87

New names are y_dc_delta_q, uv_dc_delta_q, uv_ac_delta_q.

Change-Id: I4acae1fc23a4697ce2c5a5becb8dc28ef0a4b552

This flag was added to VP8 to allow a mode where MB-level skipping
was not allowed, saving a bit per mb. It was never used in practice,
and hasn't been tested in VP9, so remove it.

Change-Id: Id450ec6904c6d06c1919508e7efc52d05cde5631

Using regular 0 and 1 constants now.

Change-Id: Ie763503cbb727847cc8f1d6506cd6f2ee607f056

Combine superblock inter predictors into a unified function that
allows configurable block width and height. The inter predictions
of block sizes smaller than 16x16 are handled differently. To be
continued on merging them later.

Change-Id: I14075959dd5e221f00c205c99ca35c1c31ef728e

So it is consistent with I8x8_PRED.

Change-Id: Iefa65124b2419690d83e526c611129c0ede29d11

The probabilities derived from these statistics are used in bitstream
writing; therefore, we should only do this when we actually decide to
use macroblock coding (over superblock coding). Derf gains +0.15%.

Change-Id: I196814c070a7c79889590658ce10a6eb07454389

The intra predictor supports configurable block sizes. It can handle
intra prediction down to 4x4 sizes, when enabled in BLOCK_SIZE_TYPE.

Change-Id: I7399ec2512393aa98aadda9813ca0c83e19af854

Rename pick_mb_modes to pick_mb_mode, since it now handles only a
single macroblock. This is consistent with pick_sb_mode handling a
single non-macroblock.

Change-Id: I896fdfa06436b2d8c24d6474718cc74420df6b3b

It is write-only.

Change-Id: I2412344688d96593cc01c038e7f51410d0f85ed0

Use sb-common version instead.

Change-Id: If2552b5a39fd2e5272f66a41c5667dda85fd3939

Change-Id: Iad69e7a3b7e470acf6094f6a52e7da69066fd552

Change-Id: I87a406fcd18ab043253ca0c009d1182fdc5c3046

Merge various super_block_yrd and super_block_uvrd versions into one
common function that works for all sizes. Make transform size selection
size-agnostic also. This fixes a slight bug in the intra UV superblock
code where it used the wrong transform size for txsz > 8x8, and stores
the txsz selection for superblocks properly (instead of forgetting it).
Lastly, it removes the trellis search that was done for 16x16 intra
predictors, since trellis is relatively expensive and should thus only
be done after RD mode selection.

Gives basically identical results on derf (+0.009%).

Change-Id: If4485c6f0a0fe4038b3172f7a238477c35a6f8d3

Merge sb32x32 and sb64x64 functions; allow for rectangular sizes. Code
gives identical encoder results before and after. There are a few
macros for rectangular block sizes under the sbsegment experiment; this
experiment is not yet functional and should not yet be used.

Change-Id: I71f93b5d2a1596e99a6f01f29c3f0a456694d728

This is a VP8-only feature (part of profile 3) that is unsupported in
VP9.

Change-Id: I78016eede8d9c834d44d4c517f3e8b8fc2a378b1

Renaming sb32_coded to prob_sb32_coded and sb64_coded to prob_sb64_coded.

Change-Id: I6de5cad00a57c3e066d53467f8c38cb6073dce11

The patch adds the flexibility to use standard EOB based coding
on smaller block sizes and nzc based coding on larger blocksizes.
The tx-sizes that use nzc based coding and those that use EOB based
coding are controlled by a function get_nzc_used().
By default, this function uses nzc based coding for 16x16 and 32x32
transform blocks, which seem to bridge the performance gap
substantially.

All sets are now lower by 0.5% to 0.7%, as opposed to ~1.8% before.

Change-Id: I06abed3df57b52d241ea1f51b0d571c71e38fd0b

Crash fix only. No functional change or testing.

Change-Id: I0c6d114d024c29fc11ae61666f5938f11b01dd6a

Almost all arguments for vp9_build_inter32x32_predictors_sb and
vp9_build_inter64x64_predictors_sb can be deduced from the first macroblock
argument.

Change-Id: I5d477a607586d05698d5b3b9b9bc03891dd3fe83

Adds an experiment to use a weighted prediction of two INTER
predictors, where the weight is one of (1/4, 3/4), (3/8, 5/8),
(1/2, 1/2), (5/8, 3/8) or (3/4, 1/4), and is chosen implicitly
based on consistency of the predictors to the already
reconstructed pixels to the top and left of the current macroblock
or superblock.

Currently the weighting is not applied to SPLITMV modes, which
default to the usual (1/2, 1/2) weighting. However the code is in
place controlled by a macro. The same weighting is used for Y and
UV components, where the weight is derived from analyzing the Y
component only.

Results (over compound inter-intra experiment)
derf: +0.18%
yt: +0.34%
hd: +0.49%
stdhd: +0.23%

The experiment suggests bigger benefit for explicitly signaled weights.

Change-Id: I5438539ff4485c5752874cd1eb078ff14bf5235a

Pearson correlation for above or left is significantly higher than for
previous-in-scan-order (absolute values depend on position in scan, but
in general, we gain about 0.1-0.2 by using either above or left; using
both basically just makes this even better). For eob branch skipping,
we continue to use the previous token in scan order.

This helps about 0.9% on derf after re-training on a limited data set.
Full re-training and results on larger-resolution clips are pending.

Note that this commit breaks trellis, so we can probably get further
gains out of it by fixing trellis at some later point.

Change-Id: Iead68e296fc3a105cca746b5e3da9555d6010cfe

Replaces the default tables for single coefficient magnitudes with
those obtained from an appropriate distribution. The EOB node
is left unchanged. The model is represeted as a 256-size codebook
where the index corresponds to the probability of the Zero or the
One node. Two variations are implemented corresponding to whether
the Zero node or the One-node is used as the peg. The main advantage
is that the default prob tables will become considerably smaller and
manageable. Besides there is substantially less risk of over-fitting
for a training set.

Various distributions are tried and the one that gives the best
results is the family of Generalized Gaussian distributions with
shape parameter 0.75. The results are within about 0.2% of fully
trained tables for the Zero peg variant, and within 0.1% of the
One peg variant.

The forward updates are optionally (controlled by a macro)
model-based, i.e. restricted to only convey probabilities from the
codebook. Backward updates can also be optionally (controlled by
another macro) model-based, but is turned off by default. Currently
model-based forward updates work about the same as unconstrained
updates, but there is a drop in performance with backward-updates
being model based.

The model based approach also allows the probabilities for the key
frames to be adjusted from the defaults based on the base_qindex of
the frame. Currently the adjustment function is a placeholder that
adjusts the prob of EOB and Zero node from the nominal one at higher
quality (lower qindex) or lower quality (higher qindex) ends of the
range. The rest of the probabilities are then derived based on the
model from the adjusted prob of zero.

Change-Id: Iae050f3cbcc6d8b3f204e8dc395ae47b3b2192c9

Change-Id: Ifa864e0acb253b238b03cdeed0fe5d6ee30a45d8

These variables are unused, and are subject to overflowing, causing
assertions when built with -ftrapv.

Change-Id: Ia00a3201af309906c05bcd4b23a643925ed6ea86

Change-Id: I75fc4eee10bee9efd419d248827290cce8e6d637

Change-Id: Ib8dacf1d2797743569771b8f699e40e1aeb085cb

The commit changed the name of files and function to remove obselete
reference to LLM and x8.

Change-Id: I973b20fc1a55149ed68b5408b3874768e6f88516

Adds probability updates for extra bits for the nzcs, code for
getting nzc stats, plus some minor cleanups and fixes.

Change-Id: If2814e7f04fb52f5025ad9f400f3e6c50a00b543

Increase the motion search range by 4x. Change MV_CLASS tree of the
entropy coding to allow two additional mv classes to cover the
extended motion vector limit. The codec determines the effective
motion search range conditioned on the actual frame dimension.

It provides coding gains:

stdhd 0.39%
yt    0.56%
hd    0.47%

Major coding performance gains are packed in several sequences with
intense motion activities, e.g., ped_1080p gains 7% at high bit-rates,
and on average 3%.

TODO: Need to further tune the rate control and motion search units.

Change-Id: Ib842540a6796fbee5a797809433ef6a477c6d78d

Also enable tx_select for keyframes.

Change-Id: Iadb1231d9fa7af0c8dce3d9b41830b93a302479e

This patch revamps the entropy coding of coefficients to code first
a non-zero count per coded block and correspondingly remove the EOB
token from the token set.

STATUS:
Main encode/decode code achieving encode/decode sync - done.
Forward and backward probability updates to the nzcs - done.
Rd costing updates for nzcs - done.
Note: The dynamic progrmaming apporach used in trellis quantization
is not exactly compatible with nzcs. A suboptimal approach has been
used instead where branch costs are updated to account for changes
in the nzcs.

TODO:
Training the default probs/counts for nzcs

Change-Id: I951bc1e22f47885077a7453a09b0493daa77883d

Split macroblock and superblock tokenization and detokenization
functions and coefficient-related data structs so that the bitstream
layout and related code of superblock coefficients looks less like it's
a hack to fit macroblocks in superblocks.

In addition, unify chroma transform size selection from luma transform
size (i.e. always use the same size, as long as it fits the predictor);
in practice, this means 32x32 and 64x64 superblocks using the 16x16 luma
transform will now use the 16x16 (instead of the 8x8) chroma transform,
and 64x64 superblocks using the 32x32 luma transform will now use the
32x32 (instead of the 16x16) chroma transform.

Lastly, add a trellis optimize function for 32x32 transform blocks.

HD gains about 0.3%, STDHD about 0.15% and derf about 0.1%. There's
a few negative points here and there that I might want to analyze
a little closer.

Change-Id: Ibad7c3ddfe1acfc52771dfc27c03e9783e054430

Fixed a couple of variable/function definitions, as well as header
handling to support 16K sequence coding at high bit-rates.

The width and height are each specified by two bytes in the header.
Use an extra byte to explicitly indicate the scaling factors in
both directions, each ranging from 0 to 15.

Tested coding up to 16400x16400 dimension.

Change-Id: Ibc2225c6036620270f2c0cf5172d1760aaec10ec